When making equipment in a factory, if we want to connect parts, we used to use welding more often. But now, with the continuous changes in various processes, when we connect, You can use this product with ring groove rivets.

So why is this product so popular now? Here is a brief introduction to the reasons.

Ring groove rivets are used to rivet two structural parts into a whole. It consists of two parts: a rivet and a nail sleeve. The rivet consists of a nail rod and a nail sleeve. When riveting, first insert the rivet into the nail hole of the connected piece, and then Put the nail sleeve on the ring groove of the rivet working section from the other side of the connected piece, then put the muzzle of the special tool - the pneumatic ring groove rivet gun on the ring groove of the rivet clamping section, and press the muzzle against the ring groove of the rivet clamping section. The end face of the nail sleeve, and then pull the trigger on the gun.

When we connected before, we used the more traditional welding method mentioned above. Therefore, as the equipment operates, these positions may become loose. At this time, we need to tighten them again.

This virtually increases our workload. If we want to reduce this unnecessary labor expenditure during use, we can use ring groove rivets.

This is because after this product is installed, the connection position can be more stable. Even if the vibration generated when the equipment moves is relatively large, the ring groove rivets are not easy to loosen, which can make our equipment run well. Therefore This is why we use this product.