Ring groove rivets are used to rivet two structural parts into one piece. They are composed of two parts: a rivet and a nail sleeve. The rivet is composed of a nail rod and a nail sleeve. When riveting, first insert the rivet into the nail hole of the connected piece. , and then put the rivet sleeve on the working section ring groove of the rivet from the other side of the connected piece, and then use the tool - the rivet muzzle of the pneumatic ring groove rivet gun to put it on the clamping section ring groove of the rivet, and tighten the rivet Press the muzzle of the gun against the end face of the nail sleeve, and then pull the trigger of the rivet gun. The rivet gun will tighten the ring groove nail rod of the clamping section of the rivet until the cracking stops.

Although ring groove rivets are blind rivets, they are not blind rivets because they are installed on both sides of the board. They provide higher shear strength and tensile strength than most other products in blind rivets. Clamp loading and vibration resistance. Made of aluminum, steel and stainless steel materials, diameter range from 3\/16" to 3\/8". The friction and adhesion generated when sliding between metal surfaces are anti-loosening Gaskets are the main cause of seizure. When seizure occurs, the material is pulled away from one surface due to its viscosity, and then the whole piece adheres to the other surface. In this process, the formed metal block will accelerate the seizure, so the entire The development speed of the process is relatively fast.

The ring groove rivet machine is different from the tightening force generated by traditional nuts and bolts using torsion rotation. The ring groove rivet uses the principle of Hooke's law. The Huck rivet gun stretches the bolt rod and pushes the collar under the action of one-way tension. Squeeze the internal smooth collar into the screw groove to form a 100% combination of the collar and the bolt to generate tightening force. This complete riveting process generally only takes 5-8 seconds. Use a Hacker rivet gun to rivet the ring groove Rivets require the following steps, and their working principles are briefly introduced. Insert the Hacker bolt into the connection hole, put the collar on the ring groove bolt, put the Hacker rivet gun head on the tail of the bolt rod, press the switch of the Hacker rivet gun, and the tool Start, the claws of the head of the rivet gun grasp the tail of the bolt, and the head pushes the collar until any gaps are removed. The head begins to mold the collar onto the annular groove of the bolt until the collar is stretched and clamped against the bolt. After the groove die of the collar on the bolt is locked and the designed clamping force is reached, the tail of the bolt is pulled apart from the bolt, and the entire installation process is completed.